Canopy Float Instructions
Set up your floating shade system in just a few steps. Before starting, ensure you’re working on level ground and have all components ready.
1. Assemble your canopy following the manufacturer's instructions.
2. Position the canopy upright so it can stand on its own.
3. Partially open the frame, spacing the legs approximately 2 feet apart from one another.
4. Remove one canopy float from your carrying bag and insert a canopy leg through the center hole of the float.
5. Take one bungee strap and feed it through the slits of the float’s center hub, wrapping it twice around the canopy leg.
6. Feed the bungee through the opposite slit and secure it by looping it over the ball end of the bungee strap.
7. Repeat steps 4–6 for the remaining three legs using the remaining three floats and bungee straps.
8. Once all four floats are attached, fully open, and lock the canopy according to the manufacturer's guidelines to ensure it's properly secured.
Anchor Bag Instructions
Your canopy float kit includes an anchor bag, a short rope with a float, and two clips, all designed to help keep your setup stable in calm, shallow water.
While the anchor adds support, it should not be relied on in strong winds or currents. Always use caution and good judgment. You can also use your own rope or anchor setup if preferred, whether you're at the beach, in a pool, or attaching the float to a boat.
1. Fill the bag about ¾ full with sand from your location.
2. Fold the top of the bag over and buckle it tightly to secure the contents.
3. Clip the two metal rings together using the attached clip.
4. Thread the other end of the rope through the handle, then clip it back onto the rope to create a secure loop.
5. Once you're done for the day, empty the sand and rinse out the bag thoroughly before storing.
Care Tips
Rinse with fresh water after each use, especially after saltwater or pool exposure. Allow to fully dry before storage. Store in a cool, dry place to extend the life of your gear.